Oce cm4010 Facsimile Manual page 72

6
To cancel scanning...
Press the [STOP] key (
• When the erase function is used, erase takes place at the edges of the original image. If you also use a reduction or an
enlargement setting, the erase width will change according to the selected ratio. For example, if the erase width setting is
1" (20 mm) and the image is reduced to 50%, the erase width will be 1/2" (10 mm).
• This function cannot be used in combination with the following functions:
Card shot, Dual Page Scan (edge erase only is possible)
To cancel an erase setting...
Touch the [Cancel] key in the screen of step 4.
).
71
Press the [BLACK & WHITE START] key
( ).
Scanning begins.
• If you inserted the original pages in the document feeder
tray, all pages are scanned.
A beep will sound to indicate that scanning is finished.
• If you are scanning the original on the document glass, scan
each page one page at a time.
When scanning finishes, place the next original and press
the [BLACK & WHITE START] key (
pages have been scanned and then press the [Read-End]
key.
A beep will sound to indicate that scanning is finished.
). Repeat until all