Panasonic KX-NS1000 Manual page 457

•
Verification Code (® 2.7.6 Verification Code Entry)
*1 SIP extensions can retrieve parked calls but cannot park calls.
*2 As a member only (not as an originator).
SIP Video Phone
Video phone calls can be established between SIP extensions with video phone capabilities.
Conditions
[General]
•
This PBX supports SIP devices that use RFC 3261, 3264, 3310, 2327, or 4028.
•
Some SIP phones may not be compatible with this PBX.
•
Before a SIP extension can be used with the PBX, the IP address of the mother board, password, and
extension number must be assigned on the SIP extension and on the PBX. Even if the IP terminal
registration mode has been set to full automatic mode or extension input mode, general SIP extensions
must be registered manually.
For details on how to register, refer to the Installation Manual.
•
When registering the SIP extension, the user ID must be the extension number of the SIP extension.
•
When a SIP extension uses the Call Hold feature, the target call is put on Consultation Hold.
•
DSP Resource Usage
Making a call from a SIP extension requires a certain number of DSP resources, depending on the codec
used. If all DSP resources are in use, this operation cannot be performed. To ensure a minimum level of
performance, DSP resources can be reserved for VoIP communication. (® 5.5.4 DSP Resource Usage)
However, DSP resources are not required for P2P calls. (® 5.2.3 Peer-to-Peer (P2P) Connection)
Installation Manual References
4.4 Virtual Cards
PC Programming Manual References
9.16 PBX Configuration—[1-1] Configuration—Slot—V-SIPEXT32—Card Property
9.17 PBX Configuration—[1-1] Configuration—Slot—V-SIPEXT32—Port Property
5.2.2 SIP (Session Initiation Protocol) Extension
Feature Guide 457