Panasonic KX-NS1000 Manual page 241

Printing Message
Time format
Conditions
[General]
•
SMDR Format
The following SMDR format can be set through system programming in order to match the paper size being
used in the printer:
a.
Page Length: determines the number of lines per page.
® 19.1 PBX Configuration—[11-1] Maintenance—Main—SMDR—
(Number of Lines)
b.
Skip Perforation: determines the number of lines to be skipped at the end of every page.
® 19.1 PBX Configuration—[11-1] Maintenance—Main—SMDR—
Length (Number of Lines)
The page length should be at least four lines longer than the skip perforation length.
Explanation:
Skip
Perforation
•
SMDR data is not deleted even if the PBX is reset.
•
If the PBX is reset during a conversation, the call will not be recorded on SMDR.
•
When a call is made from an extension to a number in the Emergency Dial Table (® 2.5.4.2 Emergency
Call), the PBX can be programmed to record the call information on SMDR both immediately after the
number is dialled and after the call ends. (Normally, the PBX records the call information only after the call
ends.)
® 19.1 PBX Configuration—[11-1] Maintenance—Main—SMDR Options—
•
The following calls are regarded as two separate calls for SMDR:
–
Calls before and after the flash/recall/EFA signal is manually sent during a conversation
–
Trunk-to-trunk calls by Call Transfer, FWD or DISA (recording each as "incoming call" and "outgoing
call")
Item
Specifies the messages that can be selected from an extension
(® 2.22.2 Printing Message).
® 14.2 PBX Configuration—[6-2] Feature—Hotel &
Charge—Main—
2—Printing Message 1–8
Controls whether time is displayed in 12-hour or 24-hour format.
® 19.1 PBX Configuration—[11-1]
Maintenance—Main—SMDR—
(12H / 24H)
Page
Length
Machine
Perforation
Description
SMDR for External Hotel Application
SMDR Format—Time Format
SMDR Format—Page Length
SMDR Format—Blank Footer
Emergency Call Notification
2.22.1 Record Log Features
Feature Guide 241