Panasonic KX-NS1000 Manual page 79

[All Calls and Busy]
•
If the forward destination is not available to answer a call, this feature is cancelled and the original
destination will ring for the following type of call:
–
Doorphone call
–
Trunk calls via the ELCOT/CLCOT/LCOT or T1 (LCOT) cards
[No Answer and Busy/No Answer]
•
No Answer Time
The number of rings before the call is forwarded is programmable for each extension.
[Follow Me]
•
This feature is only available when the original extension has set "Remote Operation by Other
Extension" to "Allow" through COS programming.
[Parallel Ringing When Forwarding to Trunk]
•
KX-NSE101, KX-NSE105, KX-NSE110 or KX-NSE120 (Activation Key for Mobile Extension) is required
to use this feature. One activation key is required for each extension that will use this feature.
•
Even though DSS buttons for the forwarding extension indicate that the extension is busy, it can still receive
calls. If another call is received, FWD—No Answer will operate as normal.
•
When the forwarding extension is a virtual PS (® 5.2.4.6 Virtual PS)
–
The No Answer Time setting is ignored: All calls are forwarded immediately, even if No Answer is
specified as the forwarding method.
–
If the forward destination is unavailable, the forwarding extension is treated as busy. (In this case,
FWD—Busy is ignored even if it is enabled.) However, if the original caller is on an analogue trunk, to
which busy signals/tones cannot be sent, the PBX will continue to try to connect to the forward
destination until a connection is established or the original caller hangs up.
•
If an extension goes on-hook while transferring a call to an extension ringing in parallel with a trunk, the
trunk will stop ringing for a moment, then begin ringing again.
•
This feature is not available when the outside destination is an ELCOT/CLCOT/LCOT trunk without reverse
circuit detection (® 2.5.4.5 Reverse Circuit). It is also not available for channels of a T1 trunk set to LCOT
type.
•
This feature may not be available depending on the specifications of the telephone network.
PC Programming Manual References
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main—Features—
Set
10.7.1 PBX Configuration—[2-7-1] System—Class of Service—COS Settings
→CO & SMDR—
→Manager—
→Optional Device & Other Extensions—
11.1.1 PBX Configuration—[3-1-1] Group—Trunk Group—TRG Settings—Main
→ CO-CO Duration Time (*60s)
→ Extension-CO Duration Time (*60s)
11.5.1 PBX Configuration—[3-5-1] Group—Incoming Call Distribution Group—Group Settings—Group Log /
Group FWD
12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings—FWD / DND
12.1.2 PBX Configuration—[4-1-2] Extension—Wired Extension—FWD/DND
12.2.1 PBX Configuration—[4-2-1] Extension—Portable Station—Extension Settings—FWD / DND
12.2.2 PBX Configuration—[4-2-2] Extension—Portable Station—FWD/DND
Call Forward to CO
Group Forward Set
Remote Operation by Other Extension
2.3.2 Call Forwarding (FWD)
FWD No Answer Timer
Feature Guide 79