Inserting And Removing The Antenna Cable - Mitsubishi MELSEC-Q EQ-V680D1 User Manual

4. SETUP AND PROCEDURES PRIOR TO OPERATION

4.6.3 Inserting and removing the antenna cable

CAUTION
CAUTION
4 - 7
When inserting or removing an antenna cable, follow the procedures below.
(1) Insertion Method
1. Hold the section of the connector that secures the cable and insert the connector
with the white dot facing upward.
2. Push the connector straight in until the connector locks.
 Do not insert the connector with the power supply
ON. Doing so results in the risk of failure.
 The connector will not lock if you push the
ring section. Be sure to hold and push the
section that secures the cable.
(2) Removal Method
1. Hold onto the ring section and pull straight back.
 The connector cannot be removed by holding
and pulling the section that secures the cable.
Pulling that section results in the risk of
breakage and damage. Do not pull the cable
with force.
 Do not remove the connector with the power
ON. Doing so results in the risk of failure.
Cable securing
section
Ring
section
Cable securing
section
Ring
section
4 - 7