Mitsubishi MELSEC-Q EQ-V680D1 User Manual page 46

5. THINGS YOU NEED TO KNOW BEFORE PROGRAMMING
(1) Using TEST mode
(1) The TEST execution contents cannot be changed after the mode has
(1) For antennas in which TEST mode is not set to Enable (0) in bits 1 and 2 of the
5 - 2
1. Set the operation mode to TEST mode.
Set the test contents to be executed in buffer memory (Un\G8000 to Un\G8002).
For TEST mode operation setting details, refer to Sections 3.4.2 (14) to (16).
Point
transitioned to TEST mode, even if you change buffer memory (Un\G8000 to
Un\G8002). Set the execution contents in buffer memory (Un\G8000 to
Un\G8002) before transitioning to TEST mode.
2. Execute TEST mode.
TEST mode operation is started using the method below based on the buffer
memory (Un\G8000 to Un\G8002) setting conditions.
• When bit 0 of intelligent function module switch 2 is set to "1," start TEST mode
by switching the test switch to "TEST".
• When bit 0 of intelligent function module switch 2 is set to "0," start TEST mode
by the above method or by turning the test mode execution request (Y15) ON
in RUN mode.
Point
intelligent function module switch, TEST mode will not start even if the test
switch is turned ON.
5
5 - 2