Mitsubishi MELSEC-Q EQ-V680D1 User Manual page 35

3. SPECIFICATIONS
Setting Value
0000 , value other below
H
00A0
H
00B0
H
00B1
H
00C0
H
00C1
H
1
00C2
＊
H
Setting Value
0001
H
0002
H
Value other than the above*
Setting Value
0001 to 0800
H H
Value other than the above*
3 - 14
(12) ID tag UID storage area (Un\G90 to Un\G93, Un\G4090 to Un\G4093)
This area stores the UID (individual identification number) of the ID tag with which
communication was performed.
(13) Data storage area (Un\G100 to Un\G1123, Un\G4100 to Un\G5123)
This area stores read data when reading is performed.
The area stores write data when writing is performed.
(14) Test operation mode specification area (Un\G8000)
This area sets the test contents to be executed.
Table 3.12 Test operation mode specification list
Communication test
Distance level
Speed level (read)
Speed level (write)
Noise level
Communication success rate
Use prohibited
*1. Use prohibited. Do not set this value. Normal operation cannot be guaranteed if
the value is set.
(15) Test operation antenna specification area (Un\G8001)
This area is used to specify an antenna when tests other than the communication
test are executed.
Table 3.13 Test operation antenna specification list
Specifies antenna 1.
Specifies antenna 2.
1
Executes the communication test.
*1. The communication test is executed when the setting value is not properly
specified.
(16) No. of processing points during testing specification area (Un\G8002)
This area is used to specify the number of bytes to be executed during testing other
than the noise level test.
Table 3.14 No. of processing points during testing specification list
Specifies the number of bytes to be executed.
1
Executes the communication test.
*1. The communication test is executed when the setting value is not properly
specified.
Description
Description
Description
3 - 14