Chapter 7 Advanced Copy Settings; Advanced Copy Basic Settings; Copy Priority Settings - Fujitsu ETERNUS DX500 S3 Configuration Manual

Chapter 7
Advanced Copy Settings
This chapter explains the required setting to perform an Advanced Copy. This chapter also provides a proce-
dure on how to perform an Advanced Copy.
7.1

Advanced Copy Basic Settings

This section describes the basic settings to use Advanced Copy.
7.1.1

Copy Priority Settings

Specify the copy priority when using the EC (*1) and OPC (*2) functions.
To set the copy priority, the host I/O load and the copy processing load must be taken into consideration. The
specified copy priority is applied not only to the next session, but also to the existing session.
*1: An EC includes ECs and RECs with direct connections.
*2: An OPC includes OPC, QuickOPC, SnapOPC, and SnapOPC+.
1
Click the [Advanced Copy] tab on the navigation of the ETERNUS Web GUI screen. Then, click [Setting]
in [Category].
2
In [Action] on the [Setting] screen, click [Modify EC/OPC Priority].
3
Select the EC/OPC priority and click the [Set] button.
Automatic Priority
•
This mode changes the EC/OPC priority automatically in response to the operating load status.
High Priority
•
This mode operates by making maximum use of internal resources.
This mode greatly affects host access performance, thus should not be used during normal operation.
Use when the operation load is low.
• Middle Priority
This mode operates slightly slower than the High Priority mode.
Select this mode when performance is greatly affected by the High Priority mode, but the copy speed
is too slow with the Low Priority mode.
• Low Priority
This mode reduces the effect on host access.
Select this mode when using EC and/or OPC during operation.
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Configuration Guide (Basic)
118
Copyright 2014 FUJITSU LIMITED
P3AM-7732-05ENZ0