Fujitsu ETERNUS DX500 S3 Configuration Manual page 67

Chapter 4 Monitoring Settings
4.2 Various Notification Settings
User setup
(1)
In [Action], click [Setup SNMP User].
The [Setup SNMP Agent User] screen appears.
(2)
In the user list of the [Setup SNMP Agent User] screen, click the [Add] button.
(3)
Enter the user name, set the required items, and click the [OK] button.
The screen display returns to the user list of the [Setup SNMP Agent User] screen.
(4)
Check the user that was set in
A confirmation screen appears.
(5)
Click the [OK] button.
The SNMP user settings are applied.
(6)
Check the setting completion message and click the [Done] button.
The screen display returns to the [Network] screen.
5
Trap setup
Set up the destination for sending the SNMP Trap.
This step is not required when ETERNUS SF Storage Cruiser is used to monitor the ETERNUS DX.
(1)
In [Action], click [Setup SNMP Trap].
The [Setup SNMP Agent Trap] screen appears.
(2)
In the trap list of the [Setup SNMP Agent Trap] screen, click the [Add] button.
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Configuration Guide (Basic)
Step (3) is added in the user list and click the [Set] button.
67
Copyright 2014 FUJITSU LIMITED
P3AM-7732-05ENZ0