Fujitsu ETERNUS DX500 S3 Configuration Manual page 101

Chapter 6 SAN Connection Settings
6.2 Server Connection Setup
12
Confirm that the ETERNUS DX iSCSI name is displayed in [Discovered targets] and that the [Status] is
[Inactive].
13
Select the iSCSI name that is to be the connection target, and click the [Connect] button.
In this example, "CM#0 CA#0 Port#0" with an iSCSI name that is specified in
ter Settings" (page 89)
[Connect To Target] appears.
14
Confirm the controller number at the end of the target name and click the [Advanced] button.
15
On the [Advanced Settings] screen, specify the following items under [Connect using] and click the
[OK] button.
Local adapter: Microsoft iSCSI Initiator
Initiator IP: IP address of the server (A in
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Configuration Guide (Basic)
is the target.
Figure 6.1)
101
Copyright 2014 FUJITSU LIMITED
"6.1.2.2 iSCSI Port Parame-
P3AM-7732-05ENZ0