Eco Mode (Kx-Nt500 Series Only) - Panasonic KX-NS1000 Installation Manual

5.8.6 ECO mode (KX-NT500 series only)

5.8.6 ECO mode (KX-NT500 series only)
ECO mode allows a KX-NT500 series IP-PT to consume less power than in normal mode.
To start ECO mode, follow the procedure below.
To start programming
Supply power
to the IP-PT.
To end programming
Return to the
Menu screen.
*1 For KX-NT551 users only
Press PROGRAM when "Searching" is displayed.
Notice
•
When a KX-NT500 series IP-PT is in ECO mode, the following limitations are applied:
–
The second Ethernet port is disabled.
–
The port of the switching hub to which the telephone is connected must be 10 Mbps (Fixed)/full
duplex.
•
For KX-NT500 series IP-PTs (software version 1.010 or later), you can specify the connection mode
(Auto Negotiation, 10 Mbps/full duplex, 10 Mbps/half duplex, 100 Mbps/full duplex, 100 Mbps/half
duplex). If a connection with Auto Negotiation fails, the connection will be made in either 10 Mbps/half
duplex or 100 Mbps/half duplex.
To exit from ECO mode, turn off the KX-NT500 series IP-PT, and then follow the procedure below.
To start programming
Supply power
to the IP-PT.
To end programming
Return to the
Menu screen.
*1 For KX-NT551 users only
Press PROGRAM when "Searching" is displayed.
252 Installation Manual
SETUP
Press "SETUP" Select "ECO Mode".
*1
when it is displayed.
STORE
Press "STORE".
SETUP
Press "SETUP" Select "ECO Mode".
*1
when it is displayed.
STORE
Press "STORE".
ENTER
The IP-PT will reboot in
ECO mode.
ENTER
The IP-PT will reboot in
normal mode.
Select "On".
Select "Off".