Panasonic KX-NS1000 Installation Manual page 189

The system capacity changes according to the value you select for System Capacity Selection. (For details
about system capacity, refer to "2.3.3 System Capacity".)
In this manual, we define the "system component type" in relation to System Capacity Selection as follows.
System Component Type
Type 1
Type 2
Type 3
System data can be converted between different system component types using Web Maintenance Console
(off-line mode).
This procedure is applicable to both minor software updates (e.g., 003.00000 ® 003.10000) and major software
updates (e.g., 002.30000 ® 003.00000). When upgrading from a version prior to 003.00000, you must select
Standard Type for System Capacity Selection.
System Component Type 1
However, there are certain conditions regarding data conversion, since system capacity differs between the
component types.
For details about the conditions, refer to "Conditions" in this section.
Parts of the system data are inherited, increased, or discarded under the regulations.
To convert between system component types
1.
Start Web Maintenance Console (Off-line mode).
2.
Click Open -Offline Mode.
3.
Click Browse to select the system data file.
4.
Select one of the following options for Select the System Capacity Type.
–
Standard Type
–
IP-Extension Type
–
System Resource Type
Click OK. The system data will be converted.
Note
This step is available only when System Capacity Selection setting is enabled.
5.
Save the system data file to the local PC.
6.
Slide the System Mode Switch to the "SYSTEM INITIALIZE" position.
7.
Restart the KX-NS1000. For details about restarting the PBX, refer to "7.1.5 Restarting the KX-NS1000".
8.
In Easy Setup, select a value for Select the System Capacity Type under System Capacity Selection.
Note
The system component type selected in this step will be over-written with the following steps.
9. After Easy Setup is complete, click Utility ® File ® File Transfer PC to PBX.
10.
Select the local file that you saved in step 5, and then click Execute.
11. Click System Control ® System Reset.
Standard Type
IP-Extension Type
System Resource Type
System Component Type 2
5.3 Starting Web Maintenance Console
System Capacity Selection
System Component Type 3
Installation Manual 189