Panasonic KX-NS1000 Installation Manual page 155

LED Indications
STACK-S (TDE) Card
Indication
CARD STATUS
Legacy Gateway
Indication
RUN
ALARM
Installing and Removing a STACK-S (TDE) Card
Before Installing the STACK-S (TDE) Card
Before you install a STACK-S (TDE) card in a PBX that has been used, make a backup of the system data in
case you want to use it later, with another PBX, etc. For details about making a backup, refer to the PC
Programming Manual of the corresponding PBX.
To use the PBX as a legacy gateway, the MPR card must be replaced with a STACK-S (TDE) card.
Note
•
For some PBXs, the appearance of the MPR card and BUS-S card may differ from the following
illustrations.
Colour
Green
Red
Colour
Green
Red
STACK-S (TDE) card status indication
•
ON: INS (In Service)
STACK-S (TDE) card status indication
•
ON: Fault
•
Flashing: OUS (Out of Service)
Status indication for legacy gateway
•
ON: Normal
•
OFF: Power off
•
Slow Flashing: Starting up
•
Moderate Flashing: STACK-S (TDE) card error
Note
LED flashing patterns are as follows:
•
Slow Flashing: 60 times per minute
•
Moderate Flashing: 120 times per minute
Alarm status indication for legacy gateway
•
ON: Alarm
•
OFF: Normal
4.6.3 STACK-S (TDE) Card (KX-NS0132)
Description
Description
Installation Manual 155