Enabling The Dhcp Server Feature - Panasonic KX-NS1000 Installation Manual

Pure ip-pbx
Hide thumbs Also See for KX-NS1000:
Table of Contents

Advertisement

5.4.2 Enabling the DHCP Server Feature

Notice
Do not change the IP address of the PBX once IP telephones are registered to the PBX using the set
IP address. The IP telephones will not operate properly if the IP address of the PBX is changed. When
an external DHCP server is used to automatically assign IP addresses, it must be configured to always
allocate the same IP address to the PBX. For details, consult your network administrator.
If an external DHCP server is in use, it must be able to use a "client identifier" option specified by RFC
2131.
If an external DHCP server is in use, the KX-NS1000 DHCP Server feature must be disabled.
The PBX will not start properly if IP addresses cannot be assigned automatically by the DHCP server
when the PBX has been set to obtain IP addresses automatically. In this case, you need to consult
your network administrator because the DHCP server in your network may not be running or a network
failure may have occurred. If the DHCP server is not available, enter IP addresses manually, then
restart the PBX. If the PBX cannot be accessed over the network, connect the PC directly to the PBX
with an Ethernet cable and access Web Maintenance Console using a direct connection.
For details about connecting the PC directly to the PBX, refer to "Direct Connection" in "5.2 PC
Connection".
During a long programming session, it is highly recommended that you periodically save the system
data to the Storage Memory Card. If the PBX undergoes a sudden power failure or if the system is
reset for some reason, all the system data in RAM will be lost. However, if system data has been saved
to the Storage Memory Card, it can be easily reloaded.
To save the system data to the Storage Memory Card while programming, click the disk button (
® Yes ® OK. Be sure to save the system data to the Storage Memory Card before restarting the PBX,
or any changes may be lost.
When no operations are performed for more than 60 minutes (default), you will be automatically logged
out from Web Maintenance Console and unsaved data will be lost.
Changing the Display Language
The language used for Web Maintenance Console can be changed after the Easy Setup Wizard has completed.
1.
Click Setup ® Users ® User Profiles.
2.
Select the check box for the Installer level account.
3.
Click
.
The Edit User screen will be displayed.
4.
Select the preferred language in Change Language.
5.
Click OK.
The screen will redisplay in the selected language immediately.
5.4.2 Enabling the DHCP Server Feature
This PBX is equipped with a DHCP Server feature. When the feature is enabled, it allows you to centrally
manage and automate the assignment of IP addresses for the devices located in same LAN using Web
Maintenance Console.
202
Installation Manual
)

Advertisement

Table of Contents
loading

Table of Contents