Eco Mode (Kx-Nt500 Series Only) - Panasonic KX-NS500 Installation Manual

5.7.6 ECO mode (KX-NT500 series only)

ECO mode allows a KX-NT500 series IP-PT to consume less power than in normal mode.
To start ECO mode, follow the procedure below.
KX-NT553/KX-NT556
To start programming
Supply power
to the IP-PT.
To end programming
Return to the
Menu screen.
KX-NT511/KX-NT551
To start programming
Supply power
to the IP-PT.
To end programming
Press HOLD to return to
the Menu screen.
Notice
•
When a KX-NT500 series IP-PT is in ECO mode, the following limitations are applied:
–
The second Ethernet port is disabled.
–
The port of the switching hub to which the telephone is connected must be 10 Mbps (Fixed)/full
duplex.
•
For KX-NT500 series IP-PTs (software version V1.010 or later), you can specify the connection mode
(Auto Negotiation, 10 Mbps/full duplex, 10 Mbps/half duplex, 100 Mbps/full duplex, 100 Mbps/half
duplex). If a connection with Auto Negotiation fails, the connection will be made in either 10 Mbps/half
duplex or 100 Mbps/half duplex.
To exit from ECO mode, turn off the KX-NT500 series IP-PT, and then follow the procedure below.
SETUP
Press "SETUP" Select "ECO Mode".
when it is displayed.
STORE
Press "STORE".
Press PROGRAM while
Select "ECO Mode".
"Searching" is displayed.
Press "STORE".
5.7.6 ECO mode (KX-NT500 series only)
ENTER
The IP-PT will reboot in
ECO mode.
Press SP-PHONE.
The IP-PT will reboot in
ECO mode.
Select "On".
Select "On".
Installation Manual 215