Panasonic KX-NS1000 Installation Manual page 178

4.13 Starting the KX-NS1000
Note
•
After the PBX is initialised, you can restore system data to the PBX that has been backed up earlier.
For details about backing up and restoring system data, refer to "6.1 Tool—System Data Backup",
"7.2.2 Utility—File—File Transfer PBX to PC" and "7.2.1 Utility—File—File Transfer PC to PBX" in
the PC Programming Manual.
•
After the PBX is initialised, you must set up the mandatory settings required for both stand-alone PBXs
and PBXs in a One-look network with Easy Setup Wizard. For details refer to "Connecting to Web
Maintenance Console" and "5.4.1 Easy Setup Wizard".
•
When a UPS is connected, make sure it is started as instructed in the documentation for the UPS.
Confirming the Trunk Connection
After the SLC2/LCOT2 card is installed, programme the PBX and connect trunks to the PBX.
If SLC2/LCOT2 card is not installed, this confirmation can be skipped.
To confirm that the trunks are successfully connected, dial [ ] [3] [7] + trunk number (3 digits) on an IP
telephone, or press the IP telephone's S-CO button. You will hear a dial tone if the trunk is available and
connected.
178 Installation Manual