Panasonic KX-NS1000 Installation Manual page 170

4.11.1 LAN Connection for the Main Unit
Signal Name
Note
•
Use an Ethernet cable with an RJ45 connector for connection to a switching hub. The cable should be
a CAT 5 (Category 5) or higher for 10BASE-T/100BASE-TX, or CAT 5e (Enhanced Category 5) or
higher for 1000BASE-T.
•
Make sure that all CAT 5/CAT 5e cables in use are not over 100 m in length.
•
Make sure to set the port of the switching hub that connects to the card to operate under "Auto
Negotiation" mode.
•
Make sure to create a spanning tree for LAN connection in order to prevent loops from occurring in a
multi-bridged environment. Otherwise, some packets may circulate for long periods of time and
eventually PBX performance system may degrade.
•
The CTI server can be used for connecting PCs on a LAN to provide third party call control CTI.
CTI connection uses the CSTA Phase 3 or TAPI 2.1 protocol. The operating system of the PC or CTI
server required for third party call control depends on your CTI application software. For details, refer
to the manual for your CTI application software.
•
When using the VLAN feature on the network, make sure that the PBX is connected to a layer 2 switch
that is IEEE 802.1Q compliant, and that is configured for VLANs. In addition, the port of the switching
hub to which the PBX is connected must be set to "Untagged". Consult your network administrator for
details.
170 Installation Manual
Connection for 1000BASE-T
Switching Hub
Pin No.
TRD0 (+) 1
TRD0 (-) 2
TRD1 (+) 3
TRD2 (+) 4
TRD2 (-) 5
TRD1 (-) 6
TRD3 (+) 7
TRD3 (-) 8
PBX (LAN Port)
Pin No.
Signal Name
1 TRD0 (+)
2 TRD0 (-)
3 TRD1 (+)
4 TRD2 (+)
5 TRD2 (-)
6 TRD1 (-)
7 TRD3 (+)
8 TRD3 (-)