Eco Mode (Kx-Nt500 Series Only) - Panasonic KX-NS500 Installation Manual

Hybrid ip-pbx
Hide thumbs Also See for KX-NS500:
Table of Contents

Advertisement

5.7.6 ECO mode (KX-NT500 series only)

ECO mode allows a KX-NT500 series IP-PT to consume less power than in normal mode.
To start ECO mode, follow the procedure below.
KX-NT553/KX-NT556
To start programming
Supply power
to the IP-PT.
To end programming
Return to the
Menu screen.
KX-NT511/KX-NT551
To start programming
Supply power
to the IP-PT.
To end programming
Press HOLD to return to
the Menu screen.
Notice
When a KX-NT500 series IP-PT is in ECO mode, the following limitations are applied:
The second Ethernet port is disabled.
The port of the switching hub to which the telephone is connected must be 10 Mbps (Fixed)/full
duplex.
For KX-NT500 series IP-PTs (software version V1.010 or later), you can specify the connection mode
(Auto Negotiation, 10 Mbps/full duplex, 10 Mbps/half duplex, 100 Mbps/full duplex, 100 Mbps/half
duplex). If a connection with Auto Negotiation fails, the connection will be made in either 10 Mbps/half
duplex or 100 Mbps/half duplex.
Note
For KX-NT511 Users
SETUP
Press "SETUP"
Select "ECO Mode".
when it is displayed.
STORE
Press "STORE".
Press PROGRAM while
Select "ECO Mode".
"Searching" is displayed.
Press "STORE".
5.7.6 ECO mode (KX-NT500 series only)
ENTER
The IP-PT will reboot in
ECO mode.
Press SP-PHONE.
The IP-PT will reboot in
ECO mode.
Select "On".
Select "On".
Installation Manual
249

Advertisement

Table of Contents
loading

Table of Contents