Panasonic KX-NS1000 Installation Manual page 198

5.4.1 Easy Setup Wizard
h.
Click Next.
Note
•
The value you select for Default value of Numbering Plan affects the default values for certain
settings, such as floating extension numbers, and has a large effect on the system. Select this
value with care. For details about the default values that are affected, refer to step 3 in this
procedure.
•
The value you select for System Capacity Selection determines the maximum numbers of virtual
trunk slots and virtual extension slots, and has a large effect on the system. Select this value with
care. For details about the number of virtual trunk slots and virtual extension slots, refer to
"2.3.3 System Capacity".
4.
In LAN Setting, the IP addresses for the PBX, DNS server, and DSP cards can be assigned automatically
through a DHCP server or entered manually.
When using a DHCP server:
a.
Select Obtain an IP address automatically.
b.
Select Obtain DNS server address automatically.
c.
Select Obtain DSP IP address automatically.
Notice
The boxes will turn grey and the IP address information will be assigned automatically.
Write down the address information assigned to the PBX for future reference.
d.
Click Next.
When not using a DHCP server:
a.
Select Use the following IP address.
b.
Enter an IP address
be specified depending on your network configuration.)
c.
Select Use the following DNS server address.
d.
Enter the preferred and alternative DNS IP addresses
e.
Select Use the following DSP IP address.
f.
Enter up to 2 IP addresses
g.
Click Next.
*1 Valid IP address range: "1.0.0.0" to "223.255.255.255"
*2 Valid subnet mask address range: "0–255.0–255.0–255.0–255" (except "0.0.0.0" and "255.255.255.255")
5.
In WAN Setting, you can select whether to use the built-in router and an IPsec (VPN) connection for
inter-site communication. If you use the built-in router, additional settings such as IP addresses are
required.
For details about the built-in router, refer to "8.6 Built-in Router".
When using the built-in router and IPSec (VPN) connection:
a.
In Built-in Router, select Active (Trial Activation Key).
Note
•
The built-in router will operate until the trial activation key expires. To continue using the
built-in router feature, the built-in router activation key (KX-NSN101) is required.
b.
In Connection Mode, select a connection type, and then specify the necessary additional settings.
198 Installation Manual
, Subnet Mask , and Default Gateway
*1 *2
for each installed DSP card.
*1
. (The default gateway may not need to
*1
.
*1