G4 Internal Switches; G4 Parameter Switches; Ip Fax Switches - Ricoh B291 Service Manual

3.2.7 G4 INTERNAL SWITCHES

The G4 internal switches (SW00 to 1F) are displayed but do not change these
settings.

3.2.8 G4 PARAMETER SWITCHES

The G4 parameter switches (SW00 to 0F) are displayed but do not change these
settings.

3.2.9 IP FAX SWITCHES

IP Fax Switch 00
No. FUNCTION
0 Not used
IP Fax Transport
1
0: TCP, 1: UDP
IP Fax single port selection
2
0: OFF, 1: ON (enable)
IP Fax double ports (single data
3 port) selection
0: OFF, 1: ON (enable)
IP Fax Gatekeeper
4
0: OFF, 1: ON (enable)
IP Fax T30 bit signal reverse
5
0: LSB first, 1: MSB first
IP Fax max bit rate setting
0: Not affected, 1: Affected
6
IP Fax received telephone number
confirmation
0: No confirmation, 1: Confirmation
7
SM
CÓPIA NÃO CONTROLADA
Do not change this setting.
Selects TCP or UDP protocol for IP-Fax
Selects single data port.
Selects whether IP-Fax uses a double port.
Enables/disables the gatekeeper for IP-Fax.
Reverses the T30 bit signal.
When "0" is selected, the max bit rate does
not affect the value of the DIS/DCS.
When "1" is selected, the max bit rate affects
the value of the DIS/DCS.
When "0" is selected, fax data is received
without checking the telephone number.
When "1" is selected, fax data is received only
when confirming that the telephone number
from the sender matches the registered
telephone number in this machine. If this
confirmation fails, the line is disconnected.
79
CÓPIA NÃO CONTROLADA
BIT SWITCHES
SP No. 1-111-001
COMMENTS
B779