Ricoh B291 Service Manual page 836

DEDICATED TRANSMISSION PARAMETERS
Switch 03
No FUNCTION
5
Compression modes available
in transmit mode
0: MH only
1: Disabled
6 ECM during transmission
7 Bit 7 Bit 6
0 0
0 1
1 0
1 1
Switch 04 - Not used (do not change the settings)
Switch 05 - Not used (do not change the settings)
Switch 06 - Not used (do not change the settings)
Switch 07 - Not used (do not change the settings)
Switch 08 - Not used (do not change the settings)
Switch 09 - Not used (do not change the settings)
B779
CÓPIA NÃO CONTROLADA
This bit determines the capabilities that are informed
to the other terminal during transmission.
If the setting is "Disabled", the bit switch setting is
used.
For example, if ECM is switched on but is not
Setting wanted when sending to a particular terminal, use
Off the (0, 0) setting.
On
Note that V.8/V.34 protocol and JBIG compression
Not used
are automatically disabled if ECM is disabled.
Disabled
If the setting is "Disabled", the bit switch setting is
used.
CÓPIA NÃO CONTROLADA
COMMENTS
98 SM