Ricoh B291 Service Manual page 308

SERVICE PROGRAM MODE TABLES
5816 208 Error Code
Displays a number that describes the error code that was issued when either
SP5816 204 or SP5816 207 was executed.
Cause
Illegal Modem Parameter
Operation Error, Incorrect
Setting
Error Caused by
Response from GW URL
5816 250 CommLog Print
Prints the communication log.
5821* Remote Service Address (Japan Only)
5821 1* CSS PI Device Code
5821 2* RCG IP Address
5824 NVRAM Data Upload
Uploads the UP and SP mode data (except for counters and the serial number)
from NVRAM on the control board to a flash memory card.
While using this SP mode, always keep the front cover open. This prevents a
software module accessing the NVRAM during the upload.
5825 NVRAM Data Download
Downloads the content of a flash memory card to the NVRAM on the control
board.
B291/B295/B296/B297
CÓPIA NÃO CONTROLADA
Code Meaning
-11001 Chat parameter error
-11002 Chat execution error
-11003 Unexpected error
-12002 Inquiry, registration attempted without
acquiring device status.
-12003 Attempted registration without execution of
an inquiry and no previous registration.
-12004 Attempted setting with illegal entries for
certification and ID2.
-2385 Attempted dial up overseas without the
correct international prefix for the telephone
number.
-2387 Not supported at the Service Center
-2389 Database out of service
-2390 Program out of service
-2391 Two registrations for same device
-2392 Parameter error
-2393 Basil not managed
-2394 Device not managed
-2395 Box ID for Basil is illegal
-2396 Device ID for Basil is illegal
-2397 Incorrect ID2 format
-2398 Incorrect request number format
Sets the PI device code. After changing this
setting, you must switch the machine off and on.
Sets the IP address of the RCG (Remote
Communication Gate) destination for call
processing at the remote service center.
[00000000h ~ FFFFFFFFh/ 00000000h /
5-48
CÓPIA NÃO CONTROLADA
SM