Ricoh B291 Service Manual page 790

BIT SWITCHES
I-fax Switch 04
No FUNCTION
0 Subject for Delivery TX/Memory Transfer
This setting determines whether the RTI/CSI registered on this machine or the RTI/CSI
of the originator is used in the subject lines of transferred documents.
0: Puts the RTI/CSI of the originator in the Subject line. If this is used, either the RTI
or CSI is used. Only one of these can be received for use in the subject line.
1: Puts the RTI/CSI registered on this machine in the Subject line.
When this switch is used to transfer and deliver mail to a PC, the information in the
Subject line that indicates where the transmission originated can be used to determine
automatically the destination folder for each e-mail.
1 Subject corresponding to mail post database
0: Standard subject
1: Mail post database subject
The standard subject is replaced by the mail post database subject in the following
three cases:
1) When the service technician sets the service (software) switch.
2) When memory sending or delivery specified by F code is applied by the SMTP
server
3) With relay broadcasting (1st stage without the Schmidt 4 function).
Note: This switch does not apply for condition 3) when the RX system is set up for
memory sending, delivery by F-code, sending with SMTP RX and when operators are
using FOL (to prevent problems when receiving transmissions).
2-7 Not Used
I-fax Switch 05
No FUNCTION
0 Mail Addresses of SMTP Broadcast Recipients
Determines whether the e-mail addresses of the destinations that receive
transmissions broadcasted using SMTP protocol are recorded in the Journal.
For example:
"1st destination + Total number of destinations: 9" in the Journal indicates a broadcast
to 9 destinations.
0: Not recorded
1: Recorded
1-7 Not Used
I-fax Switch 06 - Not used (do not change the settings)
I-fax Switch 07 - Not used (do not change the settings)
B779
CÓPIA NÃO CONTROLADA
52
CÓPIA NÃO CONTROLADA
SP No. 1-102-005
COMMENTS
SP No. 1-102-006
COMMENTS
SP No. 1-102-007
SP No. 1-102-008
SM