G4 Internal Switches - Ricoh B051 Service Manual

4.2.7 G4 INTERNAL SWITCHES

G4 Internal Switch 00
No. FUNCTION
Country code
Bit 4 3 2
0 0 0
0-7
0 0 0
1 0 0
Note: In Germany, use the Universal setting for the Euro ISDN lines.
G4 Internal Switch 01 - Not used (do not change these settings)
G4 Internal Switch 02 - Not used (do not change these settings)
G4 Internal Switch 03
No. FUNCTION
Amount of protocol dump data in
one protocol dump list
0 0: Last communication only
1: Up to the limit of the memory
area for protocol dumping
1-7 Not used
G4 Internal Switch 04
No. FUNCTION
0-2 Not used
Auto data rate change for
transmission
(64 kbps to 56 kbps)
3
0: On 1: Off
Auto data rate change for reception
(64 kbps to 56 kbps)
0: Off 1: On
4
5-7 Not used
SM
CÓPIA NÃO CONTROLADA
COMMENTS
1 0 Country
0 1 Germany (1TR6 mode)
1 0 Universal (Europe Euro ISDN)
0 1 USA
Change this bit to 0 if you want to have a
protocol dump list of the last communication
only.
This bit is only effective for the dump list D +
Bch1.
Do not change these settings.
Do not change these settings.
0: The machine automatically changes the
1: The machine automatically changes the
Do not change these settings.
93
CÓPIA NÃO CONTROLADA
COMMENTS
COMMENTS
transmission data rate from 64 kbps to 56
kbps after 3 s if the other end did not
accept the call. This is to cope with 56 kbps
networks in the USA.
Normally, keep this bit at 0.
reception data after 6 s.
Change this bit to 1 only when there is a
communication error where the other
terminal informs 64 kbps in the SETUP
signal although it is actually 56 kbps.
BIT SWITCHES
B502