Mitsubishi GT16 User Manual page 315

(b) Setup operation
Sets the project data stored in the A drive (Standard CF Card), B drive (Extended memory card) or E drive
(USB drive) to be used in the GOT.
The GOT monitors using the monitor data in the A drive or B drive.
(This item explains using the A drive.)
POINT POINT POINT
Before setup operation
When storing project data from GT Designer3 or GT Designer2 to CF card, select [A: Standard CF Card], [B:
Extended memory card] or [E: USB drive] for [Project Data] in [Boot Drive].
1.
Install the CF card or USB memory in GOT.
Refer to the following for inserting/removing
method of CF card or USB memory.
(Hardware)
8.3.2  CF card
(Hardware)
8.5.2  Install USB peripheral devices
2.
Touch [A: Standard CF Card] in Select drive.
3.
If touch the [Download] button, the dialog box
mentioned left is displayed.
If touch [OK] button, the setup is executed.
4.
When the setup is completed, the dialog box
mentioned left is displayed.
Touching the [OK] button restarts the GOT.
6.3 OS/Project Information
1
2
3
4
5
6
7
6 - 121