Table of Contents
Advertisement
(4) Channel number specification menu BOX
Set channel No. to use with standard interface or extend interface.
Refer to this section (5) for driver that can be assigned to each channel.
0
: Set when the communication interface is not used.
1 to 4
: Set when connecting to a controller.
(Except fingerprint unit, bar code reader, RFID controller and PC)
: Set when connecting to a barcode reader, an RFID controller or a PC.
1
2
5 to 7*
*
Only extend I/F setting is possible.
: Set when connecting to a fingerprint unit, a barcode reader, an RFID controller or a PC.
1
2
8*
*
Only standard I/F setting is possible.
1
: Set when connecting with PC (GT Designer3 or GT Designer2). (For USB and RS-232
9*
interface, the simultaneous setting is possible. However, when either interface is during
communication, communication is not possible for another interface.)
*
: Set when using the function that uses the gateway function (when connection types except the
Ethernet connection is used for connecting to controllers), MES interface function, Ethernet
download function, report function, hard copy (when printing), video display, RGB display,
RGB output, external I/O, operation panel function, sound output, Multimedia, CF card unit or
CF card extension unit.
• Fixed to 9 for the USB interface.
*1
Cannot be assigned with Ethernet I/F Assignment.
*2
The same device cannot be used for ChNo.5 to Ch No.8 simultaneously.
For restrictions on external devices, refer to the following manual.
•GOT1000 Series Connection Manual for GT Works3 and a controller used
(1.1 Setting the Communication Interface)
•GT Designer2 Version
(3.7 Communication Interface Setting (Communication Settings))
(5) Driver display BOX
The name of communication driver assigned to the channels or the driver set with the Communication Setting of
GT Designer3 or GT Designer2 is displayed.
For details of drivers to be displayed, refer to the following manual.
•GOT1000 Series Connection Manual for GT Works3 and a controller used
(1.1 Setting the Communication Interface)
•GT Designer2 Version
(3.7 Communication Interface Setting (Communication Settings))
Display [None] in the driver display BOX in case of the followings.
• The communication driver is not installed. (
• In channel number specification menu BOX, [0] is set.
• The communication unit type and the communication driver are mutually not corresponding at the extend
interface side.
When the channel number for the standard I/F-1 is set to [9], the communication driver [Host (PC)] or [Host
(Modem)] can be selected.
When the channel number for the standard I/F-2 is set to [9], the communication driver [Host (PC)] is
automatically assigned.
For how to set the communication driver, refer to the following.
3.1.4 Host (PC)/Host (Modem) settings
(6) Assign Ethernet I/F
The communication settings for the Ethernet connection can be made.
Ethernet I/F Assignment can assign up to four channels per interface.
3.1.4 Assign Ethernet I/F operation
Screen Design Manual
Screen Design Manual
6.3.1 OS information)
3.1 Communication Setting
1
2
3
4
5
6
7
3 - 4
Advertisement
Table of Contents
