Table of Contents
Advertisement
5.
The GOT restarts automatically after the installation is completed.
(When the standard monitor OS is already installed, the GOT restarts by touching the [OK] button.)
6.
After confirming normal restart, switch off the CF card access switch of the GOT.
Confirm that the card access LED is not lit, and remove the CF card from the CF card interface of the GOT.
(2) When installing with USB memory
1.
Power off the GOT, and install the USB memory where the BootOS, standard monitor OS or project data is
stored in the USB interface of the GOT.
The BootOS cannot be stored in the USB memory where the standard monitor OS or project data is stored.
2.
Power on the GOT.
Power on the GOT while pressing the install switch (S.MODE switch) on the back of the GOT.
(1-point press installation function)
3.
The BootOS and standard monitor OS are installed in the built-in flash memory.
The USB memory access LED is lit during the installation execution.
Do not pull out the USB memory or power off the GOT while the USB memory access LED is lit.
4.
The GOT restarts automatically after the installation is completed.
(When the standard monitor OS is already installed, the GOT restarts by touching the [OK] button.)
5.
After confirming normal restart, confirm that the USB memory access LED is not lit, and remove the USB
memory from the USB interface of the GOT.
For removing methods of the USB memory, refer to the following.
7 - 6
7.3 BootOS and Standard Monitor OS Installation Using CF Card or USB Memory
Reboot.
Now installing BootOS.
Reboot.
4.3.7 USB device status display
Advertisement
Table of Contents
