To Load A Sheet With The Roll-Feed Option Installed - HP DesignJet 330 User Manual

Working with media

To load a sheet with the roll-feed option installed

To load a sheet with the roll-feed option installed
From time to time you may want to load a separate sheet even though you
normally use a roll – for example, to use the setup sheet.
1 If a roll is currently loaded in the plotter, unload it as explained on page 2–18,
remembering to raise the green media lever again when it's done.
2
On the front panel, make sure the
light OFF, to indicate that you are
going to load a sheet.
3 Load the sheet as explained in the steps starting with step 2 on page 2–9.
2–26
This is the black on page 2–26 (seq: 66)
This is the cyan on page 2–26 (seq: 66)
Company confidential. Pelican User's Guide, Ed 1, Final. Freeze Status: frozen
Localization Note. .Treat as new.
Roll
Roll/Sheet
Roll
(OFF)