Load The Substrate - HP 54 Basic Cutter User Manual

3

Load the substrate

IMPORTANT:
The loading process is the same, whether the job is a print-and-cut job or just a cut job.
You can load both rolls and sheets of substrate into the cutter. Sheets can be loaded from the front or the rear;
rolls must be loaded from the rear.
NOTE: There are different cutter models. Your cutter may not correspond exactly to the model shown in the
illustrations.
Load a roll
1. Raise the pinch rollers with the pinch-roller lever arm, which is located at the right-hand side of the cutter,
next to the front panel.
12 Chapter 3 Load the substrate
You are strongly recommended to load the substrate before preparing the job on the computer.
ENWW