HP DesignJet 330 User Manual page 53

8
The plotter takes about a minute to check the alignment. While it's doing this,
the
Ready
either the
stops flashing, but stays
on:
Alignment good –
ready to plot!
* There is another reason why these two lights may flash: the sheet may be an invalid size. For sup-
ported media sizes, see page 10–3. With very small supported sizes (B/A3-loaded in landscape or
A/A4-size loaded in any orientation), there's no middle option above: unless the alignment is good,
you have to remove the sheet and start again.
This is the black on page 2–13 (seq: 53)
This is the cyan on page 2–13 (seq: 53)
Company confidential. Pelican User's Guide, Ed 1, Final. Freeze Status: frozen
Localization Note. .Treat as new.
light on the front panel flashes.
Wait until ...
light or the
Ready Load Media
lights starts flashing:
Load Media
Ready
Alignment close.
Either realign the
sheet manually, as
explained in the next
section, or press
Cancel to start again
from step 4 on
page 2–11.
Working with media
Loading sheet media
Ready
or the and
Error Load
Media lights start
flashing:
Load Media Error
* Alignment bad. The
plotter has rejected the
sheet. Simply remove
it and start again from
step 4 on page 2–11.
(There's no need to
press any key.)
2–13