Setting up your plotter
Task 3: Position the plotter
Task 3: Position the plotter
If you have fitted the optional roll-feed kit, you must also fit the legs assembly
for stability, so this task does not apply.
If you have not fitted the optional roll-feed and legs kit, position the plotter as
shown below.
For operating temperature and humidity, see page 10–5.
Allow enough space above the plotter to open the cover.
If the plotter is without legs ...
Level surface.
Sturdy support. For plotter
weights, see page 10–4.
Leave enough space for your largest sheet size
to hang freely from the media exit slot without
touching the ground.
1–8
This is the black on page 1–8 (seq: 22)
This is the cyan on page 1–8 (seq: 22)
Company confidential. Pelican User's Guide, Ed 1, Final. Freeze Status: frozen
Localization Note JKCT: Similar to Parrot UG, p1–9.
1739
Place the plotter at the edge of
the support, so that sheets exit
without hitting the top of the
support.