HP DesignJet 330 User Manual page 112

Reconfiguring the plotter
To upgrade the HP DesignJet 330 plotter with color
11
Remove the cover from the three left-hand cartridge selectors.
1 Release the clip on the right side of the cover, at the bottom. This is
easiest to see when looking down into the plotter.
2 Lift the cover off.
12 From the upgrade kit, take the label containing four colored dots.
1 Remove the protective strip from the back.
2 Stick the label onto the vertical panel above the cartridge stalls while the
cartridge is out of its stall, as shown below. Note that the yellow dot
must be on the left.
3 Close the cover
6–10
This is the black on page 6–10 (seq: 112)
This is the cyan on page 6–10 (seq: 112)
Company confidential. Pelican User's Guide, Ed 1, Final. Freeze Status: frozen
Localization Note. .Treat as new.
2
1913
1
This is the magenta on page 6–10 (seq: 112)
This is the yellow on page 6–10 (seq: 112)