HP DesignJet 330 User Manual page 120

Maintaining your plotter
Replacing cartridges
3
350C Match the color of the cartridge's label with the color of the dot
above the empty stall. For users with color-vision deficiencies:
you can identify the colors of the cartridges by the part numbers on
the boxes – see page 10–17.
1 Take the new cartridge out of its box.
2 Remove the colored protective tape and tab
from the cartridge's nozzles.
3 Make sure that the plotter is still switched ON.
(Never install cartridges with the plotter
switched off.)
4 Insert the new cartridge in the stall. Press down lightly and push the
cartridge away from you until it snaps into place. If it is installed correctly,
the
Ready
4 When you have finished replacing cartridges, lower the cover.
If you wish, you can now check your cartridge alignment by running the Black
Cartridge Alignment Routine (See page 5–3). However, this is normally only
required for troubleshooting.
7–6
This is the black on page 7–6 (seq: 120)
This is the cyan on page 7–6 (seq: 120)
Company confidential. Pelican User's Guide, Ed 1, Final. Freeze Status: frozen
Localization Note. Very similar to Loquillo UG p3-29.
light flashes for a second or two.
2
r0004
1
330
This is the magenta on page 7–6 (seq: 120)
This is the yellow on page 7–6 (seq: 120)
1754
Yellow
Cyan
Magenta
Black
0004
2
1
350C