Changing The Plotter's Logical Pen Characteristics - HP DesignJet 330 User Manual

Controlling your plot's appearance

Changing the plotter's logical pen characteristics

Changing the plotter's logical pen characteristics

The characteristics of the plotter's logical pens, referenced by your software, can
be set either by software or by the settings for pens 1 through 8 in the Setup Sheet.
The default is to use settings from the software.
Sometimes you may, for example, want to produce a set of drawings all with the
same pen settings, but without having to change the software settings for the
individual drawings. In this case you can choose to provide the pen settings from
the plotter.
If you want to provide your own settings in the plotter and use those, use the
Settings
Using this option, you can specify the
1 through 8.
Item
Pens
Width (mm)
Grayscale (%)
350C
Color
330 For the HP DesignJet 330, only pen
Once you have chosen your pen settings, you can change back to
from software
Note. If you want to produce black and white drawings instead of grayscale, then,
unless your driver has an option for this, choose
and set all 8 pens to
drivers supplied with the plotter, you must set this in the driver since the driver
overrides the
3–12
This is the black on page 3–12 (seq: 84)
This is the cyan on page 3–12 (seq: 84)
Company confidential. Pelican User's Guide, Ed 1, Final. Freeze Status: frozen
Localization Note. .Treat as new.
section in the Setup Sheet and select
Width
Available options
1 through 8.
0.13, 0.18, 0.25, 0.35, 0.50, 0.70, 1.00
Note that 0.13 mm is a one-pixel line width and renders
some colors as a dot pattern.
100, 80, 60, 40, 20, 10, 5
Black, Red, Green, Yellow, Blue, Magenta, Cyan
and your settings will be saved for future use if you require.
Black/100% Grayscale
in the Setup Sheet.
Pen Settings
Use settings from tables below
and of logical pens
Color/Grayscale
and are available.
Width Grayscale
Use settings
Use settings from tables below
. If you are using one of the Windows
Pen
.