Ls Cam Plate Position Adjustment - Sony HVR-Z1J Service Manual

2-4-3.

LS Cam Plate Position Adjustment

1. Adjustment Procedure
1) Loosen the LS cam plate fixing screw (special head screw
M1.4 × 1.4) by 180 degrees.
2) Set the STOP mode.
3) While pressing the center and the S side of the LS chassis block
with the force of 0.196 ± 0.05N•m (2000 ± 500 gf•cm) and
0.225 ± 0.02N•m (2300 ± 200 gf•cm) respectively, move the
LS cam plate toward the S reel side with the force of 0.147 ±
0.01N•m (1500 ± 100 gf•cm) and tighten the LS cam plate
fixing screw (special head screw No. 0 M1.4 × 1.4).
Tightening torque: 0.098 ± 0.01 N•m (1000 ± 100gf•cm)
HVR-Z1J/Z1U/Z1N/Z1E/Z1P/Z1C
Pressing the S side of the LS
chassis block with the force of
0.225 ± 0.02N•m (2300 ± 200 gf•cm).
LS cam plate fixing screw
LS cam plate
Fig. 6-2-6.
Pressing the center of the LS
chassis block with the force of
0.196 ± 0.05 N•m (2000 ± 500gf•cm).
Pin of the LS
arm assy
Move the LS cam
plate with the force
of 0.147 ± 0.01 N•m
(1500 ± 100 gf•cm)
6-110