Video System Adjustments - Sony HVR-Z1J Service Manual

Ver. 1.7 2007. 10
The changed portions from
Ver. 1.6 are shown in blue.
3-4.

VIDEO SYSTEM ADJUSTMENTS

Note1: Before perform the video system adjustments, check that the
specified value of "Origin Oscillation Check" of "CAMERA
SYSTEM ADJUSTMENT" is satisfied.
And check that the data of page: 0, address: 10 is "00". If not, set
data: 00 to this address.
Note2: NTSC model: HVR-Z1J/Z1U/Z1N
PAL model: HVR-Z1E/Z1P/Z1C
Note3: Perform the adjustments in both modes, i.e. NTSC(60i) mode and
PAL(50i) mode. (Except for "VIDEO OUT Y, Chroma Level
Check" and "COMPONENT OUTPUT Level Adjustment".)
NTSC(60i) mode:
Set the NTSC(60i)/PAL(50i) switch (DB-018 board S201) to
"NTSC(60i)".
PAL(50i) mode:
Set the NTSC(60i)/PAL(50i) switch to "PAL(50i)".
After completing the adjustments, reset the NTSC(60i)/PAL(50i)
switch to the following position.
"NTSC(60i)" (HVR-Z1J/Z1U/Z1N), "PAL(50i)" (HVR-Z1E/
Z1P/Z1C)
Switch setting:
DISP OUTPUT (OTHERS menu) .................... LCD PANEL
Order of Adjustments:
1) S VIDEO OUT Y Level Adjustment (NTSC(60i) mode)
2) S VIDEO OUT Chroma Level Adjustment (NTSC(60i) mode)
3) S VIDEO OUT Y Level Adjustment (PAL(50i) mode)
4) S VIDEO OUT Chroma Level Adjustment (PAL(50i) mode)
5) VIDEO OUT Y, Chroma Level Check
(NTSC(60i) mode (HVR-Z1J/Z1U/Z1N), PAL(50i) mode
(HVR-Z1E/Z1P/Z1C))
6) COMPONENT OUTPUT Level Adjustment
(NTSC(60i) mode (HVR-Z1J/Z1U/Z1N), PAL(50i) mode
(HVR-Z1E/Z1P/Z1C))
HVR-Z1J/Z1U/Z1N/Z1E/Z1P/Z1C
CPC lid
Screw (M2x4)
6-123
S201
PAL (50i)
R
r
NTSC (60i)
Fig. 6-3-4.