Cassette Compartment Assy - Sony HVR-Z1J Service Manual

2-3-3.

Cassette Compartment Assy

1. Removal procedure
Set the [EJ] mode.
1)
2) Press the cassette compartment down halfway. Pull the cassette
compartment damper 1 in the direction of the arrow A. Then
rotate it in the B direction, and remove it in the direction of
C.
Remove the two screws (special head screw M1.4 × 1.4) 2.
3)
4) Remove the LS chassis block assy 3 in the direction of the
arrow D.
5) Remove the pin E and groove F of the cassette compartment
assy 4 from the LS chassis groove G and pin H. Then remove
the cassette compartment block assy 4.
6) Remove the tension spring (POP UP T) (black) 5.
7) Remove the tension spring (POP UP S) (silver) 6.Then remove
the cassette compartment assy 7.
REMOVING THE CASSETTE
COMPARTMENT DAMPER
Points
to be noted
C
B
1 Cassette
compartment damper
HVR-Z1J/Z1U/Z1N/Z1E/Z1P/Z1C
6 Extension spring
Cassette compartment
assy
4 Cassette
D
A
Key Points in Re-assembling
2. Attachment procedure
Set the [ULE] mode.
1)
2) Install the tension spring (cassette compartment S) (POP UP
S) (silver) 6 in to the cassette compartment assy 7. (The
spring should be hooked on the front stay with the spring end
facing downward.)
3) Install the tension spring (cassette compartment T) (POP UP
T) (black) 5 in to the cassette compartment assy 7. (The
spring should be hooked on the front stay with the spring end
facing downward.)
4) Install the pin E and groove F of the cassette compartment
assy 4 into the LS chassis groove G and pin H.
5) In the status that the LS block assy 3 is kept open, insert it
into the grooves I and J of the LS chassis block assy.
6) Close the LS chassis block assy 3 in the direction opposite to
the arrow D, and install it with the two screws (special head
screw M1.4 × 1.4) 2 at the positions K and L in this order.
Tightening torque: 0.059 ± 0.01N•m (0.6 ± 0.1kgf•cm)
7) The cassette compartment down halfway. Pass the M portion
of the cassette compartment damper 1 through the groove at
the tip of the cassette compartment. Then pull the N portion
and fix it using tweezers or something.
(pop up S) (silver)
The spring hook
faces downward
compartment
block assy
L
2 Two screws
(M1.4 × 1.4)
Groove G
Groove I
3 LS frame
1 Cassette
compartment damper
Tip groove of cassette
compartment assy
M
6-76
Pin E
7 Cassette compartment assy
5 Extension spring
(pop up T) (black)
Groove F
K
Groove J
N
The spring
hook faces
downward
Pin H