Searching For A Recording Start Point - Index Search - Sony HVR-Z1J Service Manual

Searching for a recording start
point – Index search
You can locate the point where an index
signal is recorded (p. 44).
1
Set the POWER switch to VCR.
2
Press SEARCH MODE on the Remote
Commander repeatedly to select
[INDEX SEARCH].
3
Press . (previous)/> (next) on
the Remote Commander to select an
index point.
You can select the previous or the next
index signal of the present point on the tape.
Playback starts automatically from the
point where the index signal is recorded.
To cancel the operation
Press STOP on the Remote Commander.
b Note
• If 1 day's recording is less than 2 minutes, your
camcorder may not accurately find the index point.
• The Index search will not function correctly when
there is a blank section between recorded sections on
the tape.
56
Playback
SEARCH MODE
. / >
STOP