Video Section Adjustment; Preparations Before Adjustments; Equipment To Required - Sony HVR-Z1J Service Manual

Ver. 1.7 2007. 10

6-3. VIDEO SECTION ADJUSTMENT

3-1.

PREPARATIONS BEFORE ADJUSTMENTS

Use the following measuring instruments for video section
adjustments.
3-1-1.

Equipment to Required

1) TV monitor
2) Oscilloscope (dual-phenomenon, band width above 30 MHz
with delay mode) (Unless specified otherwise, use a 10 : 1
probe.)
3) Frequency counter
4) Pattern generator with video output terminal
5) Digital voltmeter
6) Audio generator
7) Audio level meter
8) Audio distortion meter
9) Audio attenuator
10) Regulated power supply
11) DV Alignment tapes
• Tracking standard (XH2-1A1)
Parts code: 8-967-999-03
• SW/OL standard (XH2-3)
Parts code: 8-967-997-11
• Audio operation check for NTSC (XH5-3)
Parts code: 8-967-997-51
• System operation check for NTSC (XH5-5)
Parts code: 8-967-997-61
12) Adjustment remote commander (J-6082-053-B)
13) CPC-8 jig (J-6082-388-A)
14) Extension cable (28P 0.8mm) (J-6082-566-A)
For extension between the DA-033 board (CN104) and the DB-
018 board (CN205)
Note:
Perform these adjustments of all in NTSC (60i) mode first, and
then perform these adjustments of all in PAL (50i) mode.
HVR-Z1J/Z1U/Z1N/Z1E/Z1P/Z1C
6-115