Led (D901) - Sony HVR-Z1J Service Manual

2-3-7.

LED (D901)

1. Removal procedure
1) Remove LED (D901) and the FP-826 flexible board 1 from
the retainer plate.
2) Remove soldering at the two locations A and remove LED
(D901) 2.
B
Retainer plate
LED (D901),
FP-826 FLEXIBLE BOARD
Points to be noted
• There must be no solder crack.
• There must be no scars and no
stains.
• The flexible board must have no
breakdown.
• The retainer plate and LED block
must have no deformation.
HVR-Z1J/Z1U/Z1N/Z1E/Z1P/Z1C
1 LED (D901),
FP-826 flexible board
2. Attachment procedure
1) Install the LED (D901) 2 to the FP-826 flexible board by
making soldering at the two locations A.
2) Fold the FP-826 flexible board 1 beneath the LED (D901)
with finger tip so that it is inserted into the B portion of the
retainer plate.
FP-826 flexible board
Soldering
Points to be noted
Rubber finger tip protection cover must be used.
Lead-free solder
Wire type: diameter ∅ 0.6
Soldering iron: 941 made by Hakko
Soldering iron tip: T1-1BC
Temperature of the soldering iron tip: 300 ± 10 ° C
Contacting time of soldering iron tip: within 2 sec.
FP-826 flexible board
6-80
2 LED (D901)
Soldering at the two locations A
Direction of the terminal
is specified.
LED (D901)