Conversion Gear - Sony HVR-Z1J Service Manual

2-3-24. Conversion Gear

1. Removal procedure
1) Remove the belt 1 from the conversion gear.
2) Remove the conversion gear 2 from the conversion gear shaft.
2 Conversion gear
1 Belt
Conversion
gear shaft
Points to be noted
Apply grease when installing it.
Amount of grease:
a ball of grease of 1.0 mm
diameter
HVR-Z1J/Z1U/Z1N/Z1E/Z1P/Z1C
Do not remove the capstan motor assy.
Apply Grease
Apply grease
Conversion
gear shaft
2. Attachment procedure
1) Apply grease to the conversion gear shaft.
Amount of grease: a ball of grease of 1.0 mm diameter
2) Install the conversion gear 2 in the conversion gear shaft.
3) Hook the belt 1 on the conversion gear in a slant angle and
install it by rotating the conversion gear with fingertip.
Key Points in Re-assembling
Hook the belt 1 on the
conversion gear in a slant angle.
• The belt must not override on the capstan motor block assy.
• When installing the belt, the belt must not have any twisting,
dust, scar or grease must not be splashed on belt.
6-98
BELT
The belt must not be twisted.
The belt must not override on
the capstan motor block assy.