Removing The Rear Wheel - KTM 790 ADVENTURE 2024 Owner's Manual

15.3

Removing the rear wheel

Tip
Temporarily tighten one of the axle clamp screws so
that the axle does not rotate with it.
Loosen the axle clamp screw again before compression
to allow the fork legs to align.
–
Position both brake calipers.
The brake linings are correctly positioned.
–
Mount screws
Guideline
Screw, front
brake caliper
–
Operate the hand brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point. Secure the hand brake lever in the activated position.
The brake calipers straighten.
–
Tighten screws
Guideline
Screw, front
brake caliper
–
Position wheel speed sensor
–
Mount and tighten screw
Guideline
F01962-10
Screw, front wheel
speed sensor
–
Remove the locking piece of the hand brake lever.
–
Take the motorcycle off the front lifting gear. (
–
Remove the rear of the motorcycle from the lifting gear.
( p. 87)
–
Operate the front brake and compress the fork a few times
firmly.
The fork legs straighten.
–
Tighten screws
Guideline
Screw, fork stub
F01963-11
Preparatory work
–
Raise motorcycle with rear lifting gear. (
5
on both sides but do not tighten yet.
M10x1.25 45 Nm (33.2 lbf ft)
5
on both sides.
M10x1.25 45 Nm (33.2 lbf ft)
6
in the hole.
7
.
M6 10 Nm (7.4 lbf ft)
8
.
M8 15 Nm (11.1 lbf ft)
WHEELS, TIRES 15
Loctite ® 243™
Loctite ® 243™
p. 88)
p. 87)
117