Full Break-In (Qsk) Operation - Yaesu FTDX5000 Series Operating Manual

A :
DVICE
 You may disable the CW sidetone by pressing the
[ MONI ] button. The "
firming that the Monitor is now disengaged.
 When you utilize your keyer paddle, the transmitter
will automatically be activated, and the CW charac-
ters (or a string of dots and dashes) will be transmit-
ted. When you release the keyer paddle contacts, trans-
mission will cease after a brief delay. The delay time is
user-programmable, per the discussion on page 93.
 If you reduce power using the [ RF PWR ] knob, the
ALC meter reading will increase. This is normal and
does not indicate any problem whatsoever (because in-
creased ALC voltage is being used to lower the power).
FT 5000 O
DX PERATING
U B -
SING THE UILT
" icon will turn off, con-
M
ANUAL
CW M
ODE
E K
IN LECTRONIC

Full Break-in (QSK) Operation

As shipped from the factory, the FT
tem for CW is configured for "Semi-break-in" operation.
However, using Menu item "063 A1A BK-IN", you may
change this setup for full break-in (QSK) operation,
whereby the switching is quick enough to hear incoming
signals in the spaces between the dots and dashes of your
transmission.
1. Press the [ MENU ] button to enter the Menu mode.
2. Rotate the ( VFO-A )[ SELECT ] knob to select Menu
item "063 A1A BK-IN".
3. Rotate the ( VFO-B )[ SELECT ] knob to set this Menu
FULL FULL
FULL". FULL
item to "FULL
4. Press and hold in the [ MENU ] button for two seconds
to save the new setting and exit.
O
PERATION
EYER
5000 TX/RX sys-
DX
( VFO-A )[ SELECT ] Knob
[ MENU ] Button ( VFO-B )[ SELECT ] Knob
Page 89