4.1.6 Tampering Alarm
Note this option is available for GV-VS04A, GV-VS04H (Firmware Version 1.03 or later),
GV-VS11 and GV-VS12 (Firmware Version 1.02 or later).
The Tampering Alarm is used to detect when a camera is being physically tampered. An
alarm can be generated when the camera is moved, covered up, or out of focus. The
alarm approaches include the triggered output device, e-mail alerts and system buzzer. To
have the tampering alarm, first set up these alarm approaches properly:
•
To trigger the output device when a tamper event occurs, enable the output setting and
select Tampering Alarm for the related camera. See Output Setting in 4.2.2
Input/Output Settings.
•
To trigger the e-mail alert when a tamper event occurs, enable the e-mail setting and
select Tampering Alarm for the related camera. See 4.3.1 E-Mail.
•
To trigger the system buzzer when a tamper event occurs, enable the buzzer setting.
See 4.2.4 Buzzer.
42
Figure 4-8