Tampering Alarm - GeoVision GV-VS04H User Manual

4.1.6 Tampering Alarm

Note this option is available for GV-VS04H (Firmware Version 1.03
GV-VS12 (Firmware Version 1.02 or later), GV-VS14, and GV-VS2420 / 2400.
The Tampering Alarm is used to detect when a camera is being physically tam
alarm can be generated when the camera is moved, covered
alarm approaches include the triggered output device, e-mail alerts and system buzzer. To
have the tampering alarm, first set up these alarm approaches properly:
To trigger the output dev
•
select Tampering Alarm for the related camera. See Output Setting in
Input/Output Settings.
To trigger the e-mail alert when a tamper event occurs, enable the e-ma
•
select Tampering Alarm for the related camera. See 4.3.1 E-Mail.
To trigger the system buzzer when a tamper event occurs, enable the buzzer setting.
•
See 4.2.4 Buzzer.
ice when a tamper event occurs, enable the output setting and
Figure 4-8
Administrator Mode
4
or later), GV-VS11,
pered. An
up, or out of focus. The
4.2.2
il setting and
51