GeoVision GV-Video Server User Manual page 73

3. Port Number: Match the communication port on GV-Backup Center. Or keep the
default value 30000.
4. User Name: Type a valid user name to log into GV-Backup Center.
5. Backup Video: Select the cameras that you want to back up their recordings to GV-
Backup Center.
6. Compact Video: Select the cameras that you only want to back up their Key Frames
instead of full recordings, to GV-Backup Center. This option is useful to save the
backup time.
7. Resend all files: Select this option in case of the network interruption. After the
network is recovered, all the missing data will be resent to GV-Backup Center again.
8. Password: Type a valid password to log into GV-Backup Center.
9. Enable Schedule Mode: Enable the GV-Backup Center connection on the schedule
you set in the Select Schedule Time section. Refer to 4.5 Recording Schedule for the
same settings.
10. Click Apply. The Connection Status should display "Connected" and connected time.
If the GV-Backup Center has a failover server providing the uninterrupted backup service
in case of the GV-Backup Center failure, you can also configure the connection to the
failover server.
1. Automatic Failover Support: Enable the automatic connection to the failover server
once the connection between GV-Video Server and GV-Backup Center is interrupted
for the specified time.
2. Host Name or IP Address: Type the host name or IP address of the failover center.
3. Port Number: Match the communication port on the failover server. Or keep the
default value 30000.
4. User Name: Type a valid user name to log into the failover server.
5. Password: Type a valid password to log into the failover server.
6. Click Apply.
Note: The Backup Video, Compact Video and Resend all files functions are available
for GV-VS04A, GV-VS04H (Firmware Version 1.03 or later), GV-VS11 and GV-VS12
(Firmware Version 1.02 or later).
Administrator Mode
4
65