Chapter 9 Auxiliary Device Connectors; Gv-Vs04A And Gv-Vs04H; Pin Assignment - GeoVision GV-Video Server User Manual

Chapter 9 Auxiliary Device Connectors

9.1 GV-VS04A and GV-VS04H

The 16-pin terminal block, located on the rear panel, provides interfaces for four digital
inputs, four relay outputs, an RS-485 interface, a Wiegand interface, a GPS interface and
auxiliary power. The terminal block can be used to develop applications for motion
detection, event alerts via E-mail and FTP, center monitoring by Center V2 and VSM, PTZ
control, Wiegand-interface card reader and a variety of other functions.

9.1.1 Pin Assignment

The table below lists the pin assignment for the terminal block.
Pin Function
1 Relay Output 1
2 Digital Input 1
3 Relay Output 2
4 Digital Input 2
5 Relay Output 3
6 Digital Input 3
7 Relay Output 4
8 Digital Input 4
Note: To connect the GPS module, use the Pin 9 for power supply, Pin 10 for ground, Pin
12 for GPS RX and Pin 14 for GPS TX.
9
Figure 9-1
Pin Function
9 DC 5V Out for GV-Relay Module, or GPS Module
10 Ground, or GPS Ground
11 RS 485+
12 Wiegand D0, or GPS RX
13 RS 485-
14 Wiegand D1, or GPS TX
15 Ground
16 DC 12V Out for Wiegand Card Reader
Auxiliary Device Connectors
131