GIRBAU HS-6013 Installation Instructions Manual page 5

IMPORTANT INSTRUCTIONS FOR USE AND CONSERVATION
1. EXPECTED MACHINE USE AND DON'TS. This machine has been made and designed for washing or
cleansing in a water bath, linen and textile materials without solvent impregnation or explosives. Unless
approved by the manufacturer in writing, it is not considered appropriate FOR OTHER PROCESSES.
2. Machine MATERIALS in contact with wash products are:
• Stainless Steel AISI-304 L.
• Polypropylene PP.
• EPDM and NBR.
• Borosilicate glass.
The chemicals furnisher and the machine owner will be responsible to assure that the products ARE
COMPATIBLE and will not produce machine oxidation or damage.
Notice that the hypochlorite (bleach), in certain conditions of use, generates chlorine gas.
The chlorine is a corrosive and oxidizing substance that, in elevated concentrations and temperature,
deteriorates the stainless steel and elastomers.
There are other highly oxidizing agents, such as the ozone, that can cause the same effect.
3. Periodically CLEAN machine, to prevent metallic parts corrosion, to produce higher output and for a longer
life. To clean the washing machine, use water and detergent, rinse with a damp cloth, and dry.
4. NEVER use harsh products to clean the machine and laundry room. There are products on the market,
which are highly corrosive.
5. If machine is left idle for long periods of time, it must be PROTECTED from humidity and temperature
variations.
6. FOLLOW the fabric care instructions supplied by the manufacturer, GIRBAU S.A., REFUSES ANY
RESPONSIBILITY IN CASE OF TEXTILE WEAR AND TEAR.
7. Failure due to improper machine operation may VOID WARRANTY.
8. Replacing any part of the washer can affect the machine's security.
Examples:
• Just a screw or bolt of insufficient strength could cause dangerous damage.
• A heater without an internal fuse could provoke a fire.
• An inadequate clamp can be the cause of water leaks and short circuits... etc.
The reason for which ONLY ORIGINAL GIRBAU SPARE PARTS MUST BE USED.
The incompliance of this precaution may result in a washer breakdown, a serious accident, and loss of the
warranty.
9. When asking for information on your machine, MENTION model and serial number (serial plate is located
at the rear side).
10. THE ELECTRICAL DIAGRAM IS LOCATED IN THE UNDERSIDE OF THE WASHER'S TOP COVER.
Safety Instructions
5
Cod. 429043
Rev. 02/1206