Connection To Central Vending Point - GIRBAU HS-6013 Installation Instructions Manual

3.8. Connection to central vending point (option only available in Coin Control models. Not
applicable to models in the USA/CANADA)
It is possible to connect the washer to an external central vending point by means of an adaptation circuit
installed inside the washer. This option allows payments to be made and the prices to be controlled entirely
from the central vending point.
The adaptation circuit allows the PROGRAM START command to be received from the central vending point
and at the same time, a relay contact informs the central vending point of the AVAILABILITY OF THE
WASHER to start a wash cycle.
a) PROGRAM START command. Features.
The adaptation circuit is able to receive two signals or electrical impulses of different potentials from the
central vending point. Each impulse detected by the circuit adaptor will decrease the value needed to
start the wash cycle by one unit. When the total value has been accounted for, the washer will begin the
wash cycle.
It must be pointed out that the Start Wash Program command can be overridden by pressing the STOP
button on the washer's keyboard. Refer to the PSH parameter in the Mod menu in the Advanced Coin
Control Instruction Manual on the manufacturer's Web: www.girbau.com.
Features and wiring for different inputs (see board A8 on electric circuit diagram)
- Alternating current signal: voltage between 115 and 230V. Connection terminals: X1-4 and X1-5.
- Direct current signal: voltage between 5 and 25V. Connection terminals: X1-7 and X1-8.
The minimum duration for these impulses will be 50ms (0.05 seconds).
The electrical features on the central vending point will determine the application of one or another
electrical signal.
b) AVAILABILITY OF WASHER indicator. Features.
Free voltage contact. Maximum voltage: 250V.AC.
- Machine NOT AVAILABLE. Contacts closed between terminals C and NC (X1-1 and X1-2). Washer not
in operation, door open, end of cycle or in the process of a wash cycle.
- Machine AVAILABLE. Contacts closed between terminals C and NO (X1-1 and X1-3). Washer ready to
begin a wash cycle and door closed.
Making use of the AVAILABILITY indicator will depend on the central vending point's operating features.
3.8.1. Electrical connection from the central vending point to the washer
Signal conductor
Features of the conductor: minimum section: 0.35mm2;
minimum voltage: 250V.
In the event that single wire conductors are used, they must
be protected by a protection tube.
The conductor must be fixed to the machine's inlet hole by
means of a secure joint suitable for the type of conductor.
The conductor must be protected against traction, crushing
and friction.
Additional specifications for the conductor: must comply with
the statutory regulations of the country in which it is to be
installed.
Connecting the central vending point to the washer
Disconnect and mechanically lock the external automatic
switch.
Open the machine's top cover.
Fix a conductor bracket (not supplied with the washer) to the
inlet hole and secure the conductor in place. (Vc installation
card, section 1.4. fig. 2).
Open circuit adapter box cover A. This box is located on the
side of the inverter box (fig. 13). Cut a hole in the inlet box
protector to the size of the conductor to be used.
Installation
23
fig. 13
fig 14
Cod. 429043
Rev. 02/1206