Washer Configuration - GIRBAU HS-6013 Installation Instructions Manual

Connect the communication signal wires up to the vending circuit on to terminal strip X1, according to
the instructions in the previous section (fig. 14). Close the circuit box.
Position and lock the top cover in place. Connect the electricity supply.

3.8.2. Washer configuration

In washers connected to central vending points, the configuration for the token or coin meters (parameter P)
should be configured as tokens (value to)
Refer to CONFIGURATION of COIN control in the Technical Assistance Manual on the manufacturer's Web:
www.girbau.com.
Installation
24
Cod. 429043
Rev. 02/1206